Firmware Update TX-NR1008/3008/5008, PR-SC5508 (27-10-2010)
We are pleased to offer this firmware update for the best possible performance of your AV Receiver.
TX-NR708, TX-NR808, TX-NR1008,
TX-NR3008, TX-NR5008
Stabilizes "Now Initializing" process to activate [NET/USB] mode in a busy network;
Improves the playback speed of particular VR (Variable Bit Rate) mp3 files.
PR-SC5508
Stabilizes "Now Initializing" process to activate [NET/USB] mode in a busy network;
Improves the playback speed of particular VR (Variable Bit Rate) mp3 files.
Changes the timing of volume operation start (thereby avoiding problems of no sound output after power is turned on from Standby mode with network control enabled).
Depending on the receiver model there are two ways to update
1. Network
2. USB
Link to firmware files for USB update:
TX-NR708/808
http://download.onky...0SAM7MA_104.zip TX-NR1008
http://download.onky...0SAM9MA_103.zip TX-NR3008/5008, PR-SC5508
http://download.onky...OREHAHA_104.zip We hope you enjoy the improved functionality this update provides to your AV Receiver.
Precautions for your Firmware Update
Please enter [NET/USB] mode before starting the update.
The firmware update may fail if an external HDMI control signal is input during the update procedure. Please be sure to turn off the HDMI control function (RIHD) on your A/V receiver before starting the update.
How to turn off RIHD:
In the Main menu select "7. Hardware Setup", then "7-4. HDMI".
Set " HDMI Control " to OFF.
- The firmware update should take 15 to 40 minutes (depending on receiver model). Once the update begins, don't turn off the power supply to the A/V receiver until it is time to restart it.
- Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish. If the update is not completed within two hours, turn off the power supply by pushing the ON/STANDBY button and then try updating again from the beginning.
- Updating the firmware and adjusting the settings will be done automatically, but may take some time to complete. Please follow the procedures as instructed when you update. Note that the update may fail, or cause problems for your A/V receiver, if you do any of the following:
Pull out the A/V receiver’s power cord;
Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an electrical outage);
Insert or remove the LAN cable from a device in your network when updating over a network;
Insert or remove a USB memory device from the A/V receiver when updating via USB;
Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device.
If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee.
If you see "No Update" on the front panel immediately after you have started the firmware update process, you have the latest firmware. In this case it is not necessary to do this update.
Please note: if there will be an error message or a interruption during the update over Internet, please contact our service partner in your country.
EN_Firmware_Update_Precautions.pdf
Firmware_Update_TX-NR708-808-1008_ENGLISH.pdf
Firmware_Update_TX-NR3008-5008_PR-SC5508_ENGLISH.pdf