Så här gjorde jag min.
En lokal smidesverkstad fick bistå med en 3mm aluminiumplåt 200mm bred och 480mm lång.
Lät dom bocka till en kant på 30mm.
![DSCN3350.JPG](https://www.minhembio.com/forum/uploads/monthly_12_2009/post-3117-1259698741.jpg)
Borrar två hål så att jag kan fästa glidstängerna som hör till fräsen.Fräser även en skåra i mitten på plåten.
![DSCN3356.JPG](https://www.minhembio.com/forum/uploads/monthly_12_2009/post-3117-1259700021.jpg)
Jiggen skruvas fast i arbetsstycket med en försänkt M5 maskinskruv.Eftersom skruven är försänkt självcentrerar den sig i hålet.
![DSCN3352.JPG](https://www.minhembio.com/forum/uploads/monthly_12_2009/post-3117-1259700132.jpg)
Bricka å mutter, skall senare användas låsmutter istället.
![DSCN3354.JPG](https://www.minhembio.com/forum/uploads/monthly_12_2009/post-3117-1259700166.jpg)
Dags att testa
![DSCN3353.JPG](https://www.minhembio.com/forum/uploads/monthly_12_2009/post-3117-1259700353.jpg)
Jodå det funkar perfekt.
![DSCN3355.JPG](https://www.minhembio.com/forum/uploads/monthly_12_2009/post-3117-1259700636.jpg)
Fräsen kan justeras i jiggen utan att borra en massa olika hål, minsta diameter 55mm och max 560mm
![DSCN3351.JPG](https://www.minhembio.com/forum/uploads/monthly_12_2009/post-3117-1259702158.jpg)
Redigerat av Hakon, 01 december 2009 - 22:21.